Why Taylor C801 Grill won't heat up?
If your Taylor Grill won't heat, first check if the circuit breaker has tripped and reset it if necessary. Ensure that the Master Power Switch is in the ON position. Also, make sure you've pressed a cook mode button (COOK ONLY or COOK & STAGE) to take the grill out of IDLE mode.
Safety precautions for personnel installing the grill.
Guidelines for connecting the grill to the electrical supply.
Instructions for positioning and installing the grill units.
Step-by-step guide for setting up and verifying the grill's operation.
Requirements for ensuring proper ventilation and clearance around the appliance.
Information on the required grease disposal container.
Introduction to the grill's operation and maintenance procedures.
General safety guidelines for operating the grill.
Critical warnings regarding electrical shock hazards.
Warnings about burns from heat, steam, and liquid damage.
Warnings related to high temperatures, cleaning, and chemical use.
Diagram and list of parts for the C801 model.
Diagram and list of parts for the C801 Reverse model.
Diagram and list of parts for the F802 Front Unit.
Diagram and list of parts for the P802 Pick Up Window Unit.
Diagram and list of parts for the C803 model.
Diagram and list of parts for the C803 Reverse model.
Diagram and list of parts for the C804 model.
Illustrations and part numbers for Taylor-supplied accessories.
Illustrations and part numbers for accessories obtained from Wendy's vendors.
Diagram and list of components for the C801 model.
Diagram and list of components for the C801 Reverse model.
Diagram and list of components for the F802 Front Unit.
Diagram and list of components for the P802 Pick Up Window Unit.
Diagram and list of components for the C803 model.
Diagram and list of components for the C803 Reverse model.
Diagram and list of components for the C804 model.
Explanation of symbols used on the grill's control mode display.
Description of the master power switch and its function.
Steps for daily cleaning and preparation of the grill.
Steps for removing platen release sheets from the grill.
Detailed steps for cleaning the grill platens.
Step-by-step guide for reinstalling platen release sheets.
Steps for powering on and pre-heating the grill.
Procedures for cooking patties of different sizes.
Steps for cleaning the grill after each product run.
Instructions for putting the grill into standby mode to conserve energy.
Actions to take if a cook cycle is interrupted.
How to use the "Cook to Order" mode for specific operational needs.
Detailed steps for performing nightly cleaning of the grill.
Table listing common grill issues, causes, and remedies.
Checklist for issues with patty cooking and cook cycle initiation.
Checklist for issues with controls, codes, and platen operation.
Protocol for contacting service after operating hours.
Details on the warranty periods for different parts classifications.
Information on warranty coverage for labor performed by technicians.
List of parts for C801, C801R, F802, and P802 models.
List of parts for C803, C803R, and C804 models.
List of various wiring harness parts and their compatibility.
List of panel, splash shield, and related accessory parts.
List of heater, platen, and control parts with model compatibility.
Electrical schematic for the Model C801.
Electrical schematic for the Model C801R.
Electrical schematic for the Model F802.
Electrical schematic for the Model P802.
Electrical schematic for the Models C803 and C803R.
Electrical schematic for the Model C804.
To Next Page
General