Taylor C850 Series - User Manual

Taylor C850 Series

67 pages

To Next Page

To Next Page

Loading...

Clamshell Grill

Taylor Models C850, C852, C854 & C856

This equipment chapter is to be inserted

in the appropriate section of the

Equipment Manual.

Manufactured exclusively for

McDonald's®

By

Taylor Company®

a division of Carrier Commercial

Refrigeration, Inc.

750 N. Blackhawk Blvd.

Rockton, IL 61072

McDonald's® Hotline:

(877-435-7623)

service@taylor-company.com

TABLE OF CONTENTS

WARRANTY 1............................................................

INTRODUCTION 1........................................................

SAFETY 1...............................................................

PARTS IDENTIFICATION/FUNCTION AND EXPLODED VIEW 4...............

IMPORTANT TO THE OPERATOR 18........................................

EQUIPMENT SET-UP AND CLOSE PROCEDURES 22.........................

MENU SCREENS 26.......................................................

DAILY CLEANING PROCEDURES 39........................................

TROUBLESHOOTING GUIDE 56............................................

LIMITED WARRANTY ON EQUIPMENT 58...................................

LIMITED WARRANTY ON PARTS 60........................................

ORDERING/SERVICE 63...................................................

Warranty

A warranty checkout card is shipped with every new grill that leaves the factory. The warranty checkout card is packed

in an envelope which also contains this operator's manual. Refer to the warranty checkout card and the warranty

classifications listed in the Parts Identification/Function section when service is performed on your grill.

It is recommended that the operator take the necessary time to carefully read through the complete warranty information.

contained in the warranty checkout card. Any questions or unclear statements found within the card should be made

clear to you upon delivery of the grill. Thoroughly understand your warranty protection before you begin operation.

For any questions pertaining to the Taylor Warranty, please contact your authorized Taylor distributor or Taylor

Company, a division of Carrier Commercial Refrigeration, Inc., Rockton, Illinois 61072.

This manual is for the exclusive use of licensees and employees of McDonald's Corporation.

E2016 McDonald's Corporation

All Rights Reserved

October, 2016 (Original Publication)

EM SD11

Printed in

The United States of America

Table of Contents

Questions and Answers:

C
Cody ObrienAug 15, 2025
What to do if the Taylor C850 Grill won't turn on?
- D
  David CastanedaAug 15, 2025
  If the Taylor Grill doesn't turn on when the fan interlock switch is ON, there are several possible causes: * The grill breaker may have tripped. Try resetting the breaker. * The grill's control voltage cord might be unplugged. Ensure the power cord is securely reseated. * The Ansul system may have tripped. Press the Ansul reset button to resolve this. * If none of these steps work, there may be an internal component failure, and you should call for service.
C
Chloe SinghAug 18, 2025
Why is the product undercooked on the Taylor Grill?
- J
  jcarneyAug 19, 2025
  If the product is undercooked or overcooked on the Taylor Grill, consider these possibilities: * The release material may be dirty or worn. Clean and/or replace the release sheets. * The upper platen or lower cook surface might not be clean or have carbon buildup. Follow cleaning procedures to properly clean the grill and remove carbon buildup. * The cook time may be incorrect. Increase or decrease the cook time accordingly. * The grill's gaps might be out of specification. Refer to Pg cook time adjustment procedure.
B
bbaileyAug 22, 2025
Why is the product not cooking evenly on the Taylor C850?
- R
  Rachel CookAug 22, 2025
  Uneven cooking on the Taylor Grill can stem from a few issues: * The upper platen or lower cook surface may not be clean or could have carbon buildup. Ensure you are following cleaning procedures to properly clean the grill and remove any carbon buildup. * The release sheet material could be dirty or worn. Try cleaning or replacing the release sheets. * The grill's gaps may be out of specification. Refer to Pg. 22 “Gap Validation and Calibration”.
J
jeromedavisAug 25, 2025
What to do if Taylor Grill displays “TOO COOL”?
- C
  Cindy KempAug 26, 2025
  If the Taylor Grill displays “TOO COOL”, it could be due to: * The grill not being within the specified temperature range for the selected recipe. Wait for the grill to reach the required temperature. * A tripped 3-phase breaker. Reset the breaker. * The 3-phase cord becoming unplugged from the wall. Reseat the 3-phase plug.
J
James SchwartzAug 28, 2025
Why is the product not recognized on the Taylor Grill?
- J
  Justin HodgesAug 28, 2025
  If the Taylor Grill is not recognizing the product, consider the following: * Carbon buildup on the upper and/or lower cook surfaces may be interfering with the Auto Gap settings. Remove the carbon and clean the cook surfaces. * The grill plate may have become uneven. Refer to Pg “Gap Validation and Calibration.” * The wrong product may be in use. Ensure the correct product and settings are selected. * The grill might not be set in the Auto Product Recognition mode. Ensure the grill control is set to Auto.
J
Joy CollinsSep 1, 2025
What to do if the platen will not stay down on Taylor C850?
- L
  Linda WashingtonSep 1, 2025
  If the platen won't stay down when the Standby button is pressed on the Taylor Grill, it might be because: * The cavity where the handle latches to the latch solenoid (located at the front of the grill) is dirty. Try cleaning the handle foot and/or the latch solenoid post. * If the problem persists, there may be an internal component failure, and you should call for service.
S
Stephen SotoSep 4, 2025
What does “TOO HOT” mean on the Taylor C850?
- D
  debrajonesSep 4, 2025
  If the Taylor Grill displays “TOO HOT”, it indicates that the grill is not within the specified temperature range for the selected recipe. In this case, wait for the grill to reach the temperature range required for the specified recipe.
A
Anthony BowmanSep 7, 2025
Why are eggs pooling to one side of the egg ring on the Taylor C850?
- T
  tammyharrisSep 7, 2025
  If eggs are pooling to one side of the egg ring on the Taylor Grill, it could be due to: * The grill becoming unlevel. Re-level the grill. * The grill's gaps being out of specification. Refer to Pg “Gap Validation and Calibration”.
C
cbarreraSep 12, 2025
Why is the Taylor C850 making a whistling noise when cooking with egg ring?
- A
  Abigail WellsSep 12, 2025
  If the Taylor Grill is making a loud whistling noise when cooking with an egg ring, it's likely that the egg ring is dirty, causing steam to escape. Try cleaning the egg ring.

Taylor C850 Series Specifications

General

Brand	Taylor
Model	C850 Series
Category	Grill
Language	English

Summary

Warranty Information

Introduction to the Grill

Equipment Safety Precautions

Parts Identification and Exploded Views

C850 Exploded View

Exploded view and part list for the C850 model, detailing component identification.

C852 Exploded View

Exploded view and part list for the C852 model, detailing component identification.

C850;C852 Right Side View

Right side view illustration and part list for C850/C852 models.

C850;C852 left Side View

Left side view illustration and part list for C850/C852 models.

C854 Exploded View

Exploded view and part list for the C854 model, detailing component identification.

C856 Exploded View

Exploded view and part list for the C856 model, detailing component identification.

C854;C856 Right Side View

Right side view illustration and part list for C854/C856 models.

C854;C856 left Side View

Left side view illustration and part list for C854/C856 models.

Accessories

Lists and illustrates optional accessories available for the grill unit.

Important Operator Information

Operator Interface and Controls

Details key functions and buttons on the operator interface for grill operation.

Touchscreen Menus Overview

Illustrates and labels the main and manager touchscreen menus for user interaction.

Other Symbol Definitions

Key Symbol Definitions

Explains the meaning and function of various international symbols used on the operator keys.

Equipment Set-Up and Close Procedures

Installing Upper Platen Release Sheets

Step-by-step guide for applying release sheets to the upper platen of the grill.

Care of Release Sheets

Guidelines for maintaining and handling release sheets to ensure their longevity and performance.

Start-Up Grill Procedures

Instructions for initial grill setup, including cleaning and power activation.

Menu Screens and Navigation

Main Menu Navigation and Controls

Explains navigation through the main menu screens and associated operational keys.

Manager Menu Access and Functions

Details how to access and use the manager menu for advanced settings and calibration.

Key Settings and Adjustments

Covers calibration, date/time, volume, scale, brightness, and font settings for the grill.

Data Management and Mode Selection

Managing data via USB, firmware, and selecting between grill modes (Auto/Manual).

Cooking Product Operations

Recipe Management and Selection

Guide to selecting, managing, and editing recipes for optimal product cooking.

Patty Placement Guide

Laying and Pulling Patterns

Visual guide for optimal patty placement and removal on the grill's cooking surfaces.

Standby and Cleaning Procedures

Cleaning After Each Run (Lower Release Sheets)

Procedures for cleaning the grill after each product run using lower release sheets.

Cleaning After Each Run (No Lower Release Sheets)

Procedures for cleaning the grill after each product run without lower release sheets.

Daily Cleaning Procedures - Grills Using Lower Release Sheets

Detailed daily cleaning steps for grills equipped with lower release sheets.

Daily Cleaning Procedures - Grills Not Using Lower Release Sheets

Detailed daily cleaning steps for grills not equipped with lower release sheets.

Quarterly Recovery Mode Procedures

Recovery Mode Operation

Step-by-step guide for operating the grill's quarterly recovery mode for deep cleaning.

Troubleshooting Guide

Equipment Troubleshooting

Table of common equipment problems, their probable causes, and recommended solutions.

Product Troubleshooting

Table of common product-related cooking issues and their corresponding remedies.

Limited Warranty On Equipment

Limited Warranty On Parts

Ordering and Service Information

Parts Warranty Information

References the limited warranty section for information regarding replacement parts.

Release Sheet Part Numbers

Provides specific part numbers for ordering release sheets for the grill.

Related product manuals

Preview: Taylor C850

Preview: Taylor 810 Series

Taylor 810 Series

Taylor Intelli Gap