Taylor C850 Series User Manual

56
Troubleshooting Guide
WARNING: Improper installation, adjust
ment, alteration, service or maintenance can
cause property damage, injury or death. Read
the installation, operating and maintenance
instructions thoroughly before installing or
servicing this equipment.
WARNING: Inspection, testing, and repair of
electrical equipment should be performed only by
qualified service personnel.
The grill should be disconnected from all
electricity when servicing, except when electrical tests
are required.
DANGER: Use extreme care during electrical
circuit tests. Live circuitry may be exposed.
The grill must be pulled away from the wall for
thorough cleaning. When returning the grill to its
original position, use extreme caution to smoothly and
slowly roll the grill backward into place. Failure to do
so may cause the grill to tip, and will cause severe
equipment damage or personal injury.
ENTIRE GRILL (ALL MODELS)
Equipment Troubleshooting
PROBLEM PROBABLE CAUSE REMEDY
The exhaust hood alone does not
turn on when the fan interlock
switch in the ON position.
The fan interlock switch is faulty. Call for service.
Loose or broken wires to switch. Call for service.
The grill alone will not turn on when
the fan interlock switch is in the
ON position.
The grill breaker has tripped. Reset the breaker.
The grill's control voltage cord has
become unplugged.
Reseat the power cord.
The Ansul reset tripped. Press the Ansul reset button.
Internal component failure If the problem still remains, call for
service.
The platen will not stay down when
the Standby button is pressed.
The cavity where the handle
latches to the latch solenoid (This
is located at the front of the grill.) is
dirty.
Clean the handle foot and/or the
latch solenoid post.
Internal component failure If the problem still remains, call for
service.
The grill displays “TOO COOL”. The grill is not within the specified
temperature range of the specified
recipe.
Wait for the grill to reach
temperature range for specified
recipe.
3 phase breaker tripped. Reset the breaker.
3 phase cord has become
unplugged from the wall.
Reseat the 3 phase plug.
The grill displays “TOO HOT” The grill is not within the specified
temperature range of the specified
recipe.
Wait for the grill to reach
temperature range for specified
recipe.

Taylor C850 Series Specifications

General

Brand	Taylor
Model	C850 Series
Category	Grill
Language	English