44
34. Rinse the upper and lower plates with a clean,
sanitizer-soaked grill cloth. Also rinse the
surrounding areas such as the hood, bull nose and
rear grease guard. See Figure 104.
Figure 104
35. Remember to use a clean side of the cloth with
each wiping. Discard the grill cloth in the soiled
towel pail.
36. Push the grill back into place.
37. Reinstall the upper release sheets prior to using.
See Figure 105.
Figure 105
Note: Reverse the cooking side of the release
sheets on a daily basis (example: black side on odd
days; grey or brown side on even days).
38. Using a sundae spoon, distribute two level
spoonfuls of Soy Adhesion Flakes over a warm 3
ft. (1 m.) lower grill surface, allowing the flakes to
melt. Spread on the cooking zone with a clean
squeegee. See Figure 106.
39. If not using lower release sheets, skip to step 44.
Figure 106
40. Install the lower release sheets. See Figure 107.
Figure 107
41. Squeegee the air bubbles and wrinkles out of each
release sheet. Figure 108.
Figure 108
42. Complete the Clean Mode.
To Next Page
Loading...
Need help?
General
