54
Note: If needed, pull the grill out from the wall and
stand to the side of the grill to reach the back side of the
upper platens. Pour additional KAYr QSR Heat
Activated Grill & Toaster Cleaner onto a grill cloth and
use to apply to hard to reach areas. See Figure 153.
Figure 153
21. Gather a separate bottle of KAYr QSR
Heat-Activated Grill & Toaster Cleaner and
remove the cap. Pour the entire bottle of cleaner
evenly onto the lower plate surface of the grill
along with the remainder of the first bottle. See
Figure 154.
Figure 154
Note: Make sure to coat the entire surface of the lower
plate. Use the Kay Grill Cleaning Pad Holder with Pad
if needed to spread product for full coverage of the grill
surface. See Figure 155.
Figure 155
22. Lower both of the upper platens onto the lower
plate surface coated with KAYr QSR
Heat-Activated Grill & Toaster Cleaner.
23. Allow the upper and lower plates to soak for a full
cycle - approximately 17 minutes for soak time.
24. After the cycle is completed and the upper platens
have risen, scrub the flat surface, edges and sides
of the upper platens with the Kay Double Sided
Grill Brush. Scrub until the soil liquefies. See
Figure 156.
Figure 156
Note: In order to scrub all of the edges of the upper
platens, one upper platen will need to be lowered to
reach the inside edge of both platens with the brush.
25. Make sure to have both upper platens raised before
cleaning the lower plate.
To Next Page
Loading...
Need help?
General
