9C-79C-7TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
( )( ) pp
ing the forward alarm in theing the forward alarm in the Operator Controlled modeOperator Controlled mode, depress the F3 button to enable or disable the, depress the F3 button to enable or disable the
forward alarm. forward alarm. When the forward alarm When the forward alarm is disabled, no audible sound is disabled, no audible sound will be emitted by will be emitted by the forward alarmthe forward alarm
when the electric shifter is placwhen the electric shifter is placed in its Forward position. ed in its Forward position. A Forward Alarm Off tA Forward Alarm Off text message will be dis-ext message will be dis-
played on the Main Display played on the Main Display screen (refer to Illusscreen (refer to Illustration 9C-12) when the ftration 9C-12) when the forward alarm is disabled. orward alarm is disabled. WhenWhen
the forward alarm is enabled, an audible sound will be emitted by the forward alarm once the electric shift-the forward alarm is enabled, an audible sound will be emitted by the forward alarm once the electric shift-
er is placed in its Forward position.er is placed in its Forward position.
FORWARD ALARM OFFFORWARD ALARM OFF
FORWARD ALARM ONFORWARD ALARM ON
Illustration 9C-12. Illustration 9C-12. Main Display Main Display Screen (Forward Screen (Forward Alarm Operation -Alarm Operation -
Operator Controlled ModeOperator Controlled Mode
))
Automatic Powershift Control (APC).Automatic Powershift Control (APC). The APCThe APC
module controls shiftmodule controls shifting parameters. ing parameters. The TThe Tayloraylor
Integrated Control System (TICS) monitors theIntegrated Control System (TICS) monitors the
APC module via CAN-bus. APC module via CAN-bus. The TICS system willThe TICS system will
signal the APC to go to Neutral Lock when thesignal the APC to go to Neutral Lock when the
operator vacates the seat or alternate idle isoperator vacates the seat or alternate idle is
activated.activated.
Should any truck equippedShould any truck equipped
with an APC module require welding on with an APC module require welding on itsits
structural members, the RS connector must bestructural members, the RS connector must be
unplugged from the APC module prior to anyunplugged from the APC module prior to any
welding. welding. Failure to Failure to comply with comply with this cautionthis caution
may lead to damage to the APC module.may lead to damage to the APC module.
To Next Page
Loading...
