4-14-1TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
employer, and obtain medical attention.employer, and obtain medical attention.
Never rely on a control deviceNever rely on a control device
to reduce to reduce carbon moncarbon monoxide outpuoxide output. t. CarbonCarbon
monoxide levels can change depending onmonoxide levels can change depending on
maintenance. maintenance. Make sure Make sure carbon carbon monoxidemonoxide
level testing is included in regular maint-level testing is included in regular maint-
enance procedures and that ventilation is usedenance procedures and that ventilation is used
as the primary control for emissions.as the primary control for emissions.
Maintenance.Maintenance. There is There is minimal minimal maintenancemaintenance
required on the standard exhaust system.required on the standard exhaust system.
1.1. CheCheck fck for leor leaks aks at alat all pipl pipe cone connecnectiotions.ns.
2.2. CheCheck fock for holer holes in the ms in the mufufflefler and exhr and exhausaustt
piping.piping.
3.3. KeeKeep mufp mufflefler gur guard card clealean and n and in plin placeace..
4.4. KeKeep guep guarard cld cleaean and in and in pln placace.e.
5.5. KeeKeep hap handlndle ce clealean an and ind in pn placlace.e.
3.3. WaWash tsh the exhe exhaust haust purifpurifier bier by usy using sing steam team oror
high pressure water [not greater than 100 psihigh pressure water [not greater than 100 psi
(7 bar)], keeping the tip of the nozzle at least 2(7 bar)], keeping the tip of the nozzle at least 2
inches away inches away from the facfrom the face of the e of the catalyst. catalyst. DoDo
not use detnot use detergents. ergents. Wash Wash the exhaust purifierthe exhaust purifier
through both through both the inlet the inlet and outlet and outlet ends. ends. Contin-Contin-
ue the washing operation until the water, com-ue the washing operation until the water, com-
ing from the exhaust purifier, is clear or almosting from the exhaust purifier, is clear or almost
clear.clear.
4.4. Dry tDry the exhhe exhausaust purit purifiefier witr with comh comprespressed aised airr
(no greater than 100 psi), keeping the nozzle(no greater than 100 psi), keeping the nozzle
at least 2 at least 2 inches (5.1 centiminches (5.1 centimeters) awayeters) away. . TheThe
purpose of this operation is to remove aspurpose of this operation is to remove as
much water from the exhaust purifier as pos-much water from the exhaust purifier as pos-
sible. sible. The exhaust The exhaust purifier should purifier should now benow be
clean.clean.
5.5. PlaPlace thce the exhe exhausaust purt purifiifier bacer back intk into theo the
exhaust systexhaust system and em and operate the operate the engine. engine. BeBe
sure to tighten all clamps and fittings assure to tighten all clamps and fittings as
necessary.necessary.
To Next Page
Loading...
