TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
6-426-42
DEPRESS TO TOGGLEDEPRESS TO TOGGLE
BETWEEN RAW ANDBETWEEN RAW AND
SCALED VALUESSCALED VALUES
Engine Fault Code Measure GroupEngine Fault Code Measure Group
Valve Current Setting Adjustments
Valve Current Setting Adjustments
The valves (used to actuate The valves (used to actuate the tilt and hoist functionsthe tilt and hoist functions) are controlled by output modules. ) are controlled by output modules. There are fourThere are four
settings that can be adjusted for each function and the range of values allowed is controlled by the soft-settings that can be adjusted for each function and the range of values allowed is controlled by the soft-
ware. ware. These parameters (minimum current, mThese parameters (minimum current, maximum current, start ramp taximum current, start ramp time and stop ramp time) areime and stop ramp time) are
set by Tset by Taylor personnel during the initial set up of the truck. aylor personnel during the initial set up of the truck. It may be necessary to adjust these settingsIt may be necessary to adjust these settings
over time due to over time due to component wear or replacement. component wear or replacement. These values are accThese values are accessed through the operationalessed through the operational
display, via the adjust groups.display, via the adjust groups.
Perform the following procedures to adjust the settings:Perform the following procedures to adjust the settings:
To Next Page
Loading...
