9-39-3TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
,,
provide a suitable container to catch anyprovide a suitable container to catch any
draining oil, and unscrew filter and dispose ofdraining oil, and unscrew filter and dispose of
filter pfilter properlyroperly..
2.2. AppApply an ely an even fven film oilm of frf fresh oesh oil to til to the gahe gaskeskett
surface of the replacement filter and thensurface of the replacement filter and then
thread filter onto filter head.thread filter onto filter head.
3.3. HanHand tigd tightehten filn filter 3ter 3/4 tu/4 turn pasrn past poit point whnt whereere
gasket first contacts filter head surface.gasket first contacts filter head surface.
44.. RReeffeer r ttoo Filling The TransmissionFilling The Transmissionfor addingfor adding
oil to the transmission.oil to the transmission.
Changing The Transmission OilChanging The Transmission Oil (Illustration(Illustration
9-1)9-1).. The transmission oil should be changedThe transmission oil should be changed
periodically (refer to theperiodically (refer to the Preventive MaintenancePreventive Maintenance
chart in thechart in the AppendicesAppendicesfor transmission oilfor transmission oil
change interval).change interval).
Death or serious injury couldDeath or serious injury could
result from result from a runaway truck. a runaway truck. Park truck on Park truck on aa
hard, level surface, apply parking brake, blockhard, level surface, apply parking brake, block
wheels in both directions to prevent movementwheels in both directions to prevent movement
of truck and Lock Out & of truck and Lock Out & TTag Out truck beforeag Out truck before
servicing truck.servicing truck.
Dispose of transmission oilDispose of transmission oil
and filter in accordance with federal and localand filter in accordance with federal and local
regulations.regulations.
Perform the following procedures to change thePerform the following procedures to change the
transmission oil:transmission oil:
1.1. ProProvidvide a suite a suitablable conte containainer and reer and removmove thee the
drain plug to drain the oil.drain plug to drain the oil.
2.2. RemRemove ove the the oil oil scrscreen een and and gasgasketket..
8.8. OpeOperatrate the e the engengine aine and chnd check feck for leor leaksaks..
When the transmission’s oil temperatureWhen the transmission’s oil temperature
reaches 180 to 200reaches 180 to 200
F+ (82 to 93F+ (82 to 93
F+), make aF+), make a
final oil check and add oil to bring the oil levelfinal oil check and add oil to bring the oil level
to the FULL mark on the dipstick.to the FULL mark on the dipstick.
Filling The TransmissionFilling The Transmission (Illustration 9-1).(Illustration 9-1).
Perform the following procedures to fill the trans-Perform the following procedures to fill the trans-
mission with oil:mission with oil:
1.1. WitWith the enh the engine sgine shut dohut down, fwn, fill thill the trane transmismis-s-
sion to the LOW mark on the dipstick.sion to the LOW mark on the dipstick.
2.2. OpeOperatrate the e the engengine aine and chnd check feck for leor leaksaks..
When the transmission’s oil temperatureWhen the transmission’s oil temperature
reaches +180reaches +180
F to +200F to +200
F (+82F (+82
F to +93F to +93
F)F)
and the engine operating at low idle, make aand the engine operating at low idle, make a
final oil check and add oil to bring the oil levelfinal oil check and add oil to bring the oil level
to the FULL mark on the dipstick.to the FULL mark on the dipstick.
Cleaning The Transmission Breather.Cleaning The Transmission Breather. TheThe
breather should be checked for restriction andbreather should be checked for restriction and
cleaned periodically (refer to thecleaned periodically (refer to the PreventivePreventive
MaintenanceMaintenance chart in thechart in the AppendicesAppendicesfor trans-for trans-
mission breatmission breather cleaning her cleaning interval). interval). The preva-The preva-
lence of dirt and dust will determine the frequencylence of dirt and dust will determine the frequency
at which at which the breather the breather requires cleaning. requires cleaning. PerformPerform
the following procedures to clean the transmissionthe following procedures to clean the transmission
breather:breather:
1.1. CleClean than the aree area aroua around thnd the breae breathether befr beforeore
removing it.removing it.
NOTE:NOTE: Care must Care must be exercised be exercised when removingwhen removing
the breather to avoid damaging the breather.the breather to avoid damaging the breather.
2.2. ReRemomove ve ththe be brereatatheherr..
3.3. WaWash tsh the brhe breatheeather thr thoroughloroughly in y in solvesolvent ant andnd
dry it with dry it with compressed air.compressed air.
4.4. Re-Re-insinstaltall l the the brebreathatherer..
To Next Page
Loading...
