TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
1-161-16
PPrroobblleemm CCaauussee CCoorrrreeccttiioonn
4.4. EnEngigine sne statartrts, s, bubutt
will not keepwill not keep
runningrunning
1.1. LoLow fw fueuel ll levevelel..
2.2. BatBattertery voy voltaltage sge supplupply to ty to the elhe elec-ec-
tronic control module (ECM) tronic control module (ECM) is low,is low,
interrupted, or open.interrupted, or open.
3.3. EleElectrctronionic fac fault cult codes odes are aare actictive.ve.
1.1. FiFill ll fufuel el tatanknk..
2.2. CheCheck ck the the batbattertery cy connonnectectionions.s.
3.3. RefRefer ter to Coo Correrrectiction 2on 2. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
5.5. EnEngigine ne sspepeeded
surges at low orsurges at low or
high idlehigh idle
1.1. LoLow fw fueuel ll levevelel..
2.2. EleElectrctronionic fac fault cult codes odes are aare actictive.ve.
3.3. MoiMoistusture ire is in s in the the wirwiring ing harharnesnesss
connectors.connectors.
4.4. AiAir is r is in tin the fhe fueuel syl syststemem..
5.5. IncIncorrorrect ect fuefuel grl grade ade is bis beineing usg useded
or fuel quality is poor.or fuel quality is poor.
1.1. FiFill ll fufuel el tatanknk..
2.2. RefRefer ter to Coo Correrrectiction 2on 2. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
3.3. Dry Dry the the conconnecnectortors wis with th an ean eleclec--
tronics tronics cleanercleaner..
4.4. RefRefer ter to Coo Correrrectiction 6on 6. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
5.5. Use Use the the corcorrecrect gt gradrade oe of ff fueluel..
6.6. EnEngigine ne ruruns ns rorougughh
at idleat idle
1.1. EnEngigine ne is is cocoldld..
2.2. EleElectrctronionic fac fault cult codes odes are aare actictive.ve.
3.3. IdlIdle spee speed is ed is set set too ltoo low fow for acor accesces--
sories.sories.
4.4. AiAir is r is in tin the fhe fueuel syl syststemem..
5.5. FuFuel sel supupplply is ry is resestrtricicteted.d.
6.6. EnEngigine mne mounounts ats are wre wororn orn or
damaged.damaged.
7.7. MoiMoistusture ire is in s in the the wirwiring ing harharnesnesss
connectors.connectors.
8.8. IncIncorrorrect ect fuefuel grl grade ade is bis beineing usg useded
or fuel quality is poor.or fuel quality is poor.
1.1. AllAllow tow the ehe engingine tne to wo warm arm to to operoper--
ating ating temperature. temperature. If If the the engineengine
will not reach operating tempera-will not reach operating tempera-
ture, refer to Problem 16. of thisture, refer to Problem 16. of this
troubleshooting chart.troubleshooting chart.
2.2. RefRefer ter to Coo Correrrectiction 2on 2. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
3.3. CheCheck ck and and adjadjust ust the the low low idlidlee
screw.screw.
4.4. RefRefer ter to Coo Correrrectiction 6on 6. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
5.5. CheCheck fck fuel luel lineines for s for resrestritrictictionsons..
6.6. ReReplplacace ene engigine mne mouountnts.s.
7.7. Dry Dry the the conconnecnectortors wis with th an ean eleclec--
tronics tronics cleanercleaner..
8.8. Use Use the the corcorrecrect gt gradrade oe of ff fueluel..
7.7. EnEngigine ne ruruns ns rorougughh
or misfiresor misfires
continuedcontinued
1.1. EnEngigine ne is is cocoldld..
2.2. EleElectrctronionic fac fault cult codes odes are aare actictive.ve.
3.3. AiAir is r is in tin the fhe fueuel syl syststemem..
1.1. RefRefer ter to Coo Correrrectiction 1on 1. of . of ProProbleblemm
6. in this troubleshooting chart.6. in this troubleshooting chart.
2.2. RefRefer ter to Coo Correrrectiction 2on 2. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.
3.3. RefRefer ter to Coo Correrrectiction 6on 6. of . of ProProbleblemm
2. in this troubleshooting chart.2. in this troubleshooting chart.