6-196-19TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
CAB MODULECAB MODULE
(XA(XA
22
-A1)-A1)
CHASSIS MODULECHASSIS MODULE
(XA(XA
22
-A0)-A0)
TICS Control Module Locations On The TruckTICS Control Module Locations On The Truck
Measure GroupsMeasure Groups
Measure groups are used to check the status of inputs, outputs and logic parameters within the truck con-Measure groups are used to check the status of inputs, outputs and logic parameters within the truck con-
trol program. trol program. The measure groups are brokThe measure groups are broken into two subgroups, en into two subgroups, function groups and maintenancefunction groups and maintenance
groups. groups. The function groups show all datThe function groups show all data related to a particular function wa related to a particular function within the truck control program.ithin the truck control program.
Function groups are primarily used by Function groups are primarily used by TMW personnel during truck set TMW personnel during truck set up and troubleshooting. up and troubleshooting. TheThe
maintenance groups are set up to be used by the maintmaintenance groups are set up to be used by the maintenance personnel of the end userenance personnel of the end user. . These groupsThese groups
show the status of all show the status of all inputs and outputs related to the notinputs and outputs related to the noted function. ed function. These groups are to be used toThese groups are to be used to
aid the end user in diagnosing and solving any problems with daily operation of the truck.aid the end user in diagnosing and solving any problems with daily operation of the truck.
To access the Maintenance Groups inside the Taylor Integrated Control System (TICS) display module,To access the Maintenance Groups inside the Taylor Integrated Control System (TICS) display module,
perform the following procedures:perform the following procedures:
To Next Page
Loading...
