Tazz 18493 - FEATURES & CONTROLS; Control Functions

Operator’s Manual
Chipper Shredders
3
Check for parts online at www.tazztools.com or call 800-345-6007 M-F 8-5
Control Functions
The information below briey describes the function of individual controls. Operating requires the combined use of several controls
applied in specic sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section.
*For engine features and controls see engine manual.
FEATURES & CONTROLS
Chipper Cone/Shredder Hopper
Chipper Cone: The chipper cone is located on the front of the unit next to the engine. Insert branches and tree limbs up to ap-
proximately 3” (7.6 cm) in diameter into the chipper cone. NEVER insert hands past the mouth of the cone.
Shredder Hopper: The shredder hopper is on top of the unit. Leaves and other light waste can be loaded into the shredder hop-
per. Nothing over 1/2 inch in diameter should go into shredder. NEVER insert hands into the hopper .
Debris Bag: Use the debris bag to collect the material discharged from the unit. Do not operate the unit without the debris bag
in place.
SHREDDER HOPPER
CHIPPER CONE
KICKSTAND
DEBRIS BAG CONNECTOR
FUEL CAP