installed drivers.
# shutdown –r now
4) After reboot check that the newly installed driver is loaded correctly:
# dmesg | grep TBS
5) If everything is OK, the output from the above command should be similar to:
if everything is OK, the output from the above command should be similar to:
e.g.
a. for the TBS-5925 USB device (UBUNTU) :
# dmesg |grep TBS
[ 1.468829] usb 1-6: Product: TBS-5925
[ 1.468832] usb 1-6: Manufacturer: TBS-Tech
[ 13.960367] dvb-usb: found a 'TBS 5925 DVB-S2 USB2.0' in cold state, will try to load a firmware
[ 14.079021] tbs5925: start downloading TBS5925 firmware
[ 14.196012] dvb-usb: found a 'TBS 5925 DVB-S2 USB2.0' in warm state.
[ 14.196206] DVB: registering new adapter (TBS 5925 DVB-S2 USB2.0)
[ 14.484325] tbs5925: TBS 5925 FE Attached.
[ 14.486426] dvb-usb: TBS 5925 DVB-S2 USB2.0 successfully initialized and connected.
b. for the TBS-5925 USB device (CENTOS) :
# dmesg |grep TBS
[root@sadca-pc1 ~]# dmesg |grep TBS
usb 2-1.6: Product: TBS-5925
usb 2-1.6: Manufacturer: TBS-Tech
dvb-usb: found a 'TBS 5925 DVB-S2 USB2.0' in cold state, will try to load a firmware
tbs5925: start downloading TBS5925 firmware
dvb-usb: found a 'TBS 5925 DVB-S2 USB2.0' in warm state.
DVB: registering new adapter (TBS 5925 DVB-S2 USB2.0)
tbs5925: TBS 5925 FE Attached.
dvb-usb: TBS 5925 DVB-S2 USB2.0 successfully initialized and connected.
4.3 Channel Tuning and reception software
The reception and decoding is managed by the EUMETSAT “dvb-eumetcast” service.
The package and installation instructions are available for download here:
EUMETCast_Licence_cd/Linux/DVB_devices/Common_Apps/
Please use the latest version (1.2 or later). Older versions are included only for older linux
distributions if the latest version is not supported.
Follow the instruction from Readme_dvb-eumetcast.txt to install and run the service.
To Next Page
Loading...