41
VSS™FP - FILM & POST
Lo Damp Freq
(20Hz - 200Hz) Sets the Lo Cut frequency for the next
parameter, Lo Damp. Use these two parameters to take away
any objectionable low frequencies entering the Reverb tail
processor.
Lo Damp
(-18dB - 0dB) Sets the amount of cut in dBs. Used with the
previous parameter, Lo Damp Freq.
Modulation
The Reverb Mod and the Space Mod work on the tail of the
reverb and give you the ability to tweak the tail in different
ways.
To isolate and listen only to the tail you should turn the Early
level off; set the mix to 100% and then turn the Depth
parameter all the way up.
Try changing the Type of Modulation and listen to its effect
on the tail. Be aware that by using extensive modulation of
the tail you might get a detuning effect of the source material.
In that case reduce the Width and Depth.
Reverb Mod
Type
(Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild)
Adjusts the type of modulation.
Rate
(-100, default, +100) Allows you to offset the speed of the
LFO from the factory default assigned to each Type.
Width
(0% - 200%) Sets the Width of the modulation.
Space Mod
This group of parameters sets the way the sound moves about
the room.
Type
(Off, Normal, Fast, Slow, MidFreq, Sync).
Rate
(-100, default, +100) Allows you to offset the speed of the
LFO from the factory default assigned to each type.
Width
(0% - 100%) Sets the width of the modulation.
Depth
(-50, default, +50) Allows you to offset the amount of space
modulation from the factory default.
To Next Page
Loading...
Need help?
General
