Need help?Do you have a question about the TC-Helicon HARMONY SINGER 2 and is the answer not in the manual?
General| Type | Effects pedal |
|---|---|
| Proper use | Concert/Studio |
| Compatibility | TC HELICON MP-75 Sennheiser e835 FX. |
| Product color | Beige, Blue |
| Frequency range | 20 - 20000 Hz |
| Housing material | Metal, Rubber |
| Compatible products | EN 55103-1, EN 55103-2 FCC part 15, Class B, CISPR 22, Class B IEC 65, EN 60065, UL6500 and CSA IEC 65, EN 60065, UL6500 and CSA |
| Main out | 1 |
| Power consumption (typical) | 6 W |
Weight and Dimensions| Depth | 60 mm |
|---|---|
| Width | 90 mm |
| Height | 140 mm |
| Weight | 420 g |
Selects the harmonies blended with your voice. Refer to Chapter 2 for details.
Adjusts the volume of the harmonies.
Selects reverb type and amount; turn fully counterclockwise to turn off.
Indicates battery level: green (full), yellow (partial), red (change needed).
Engages adaptive EQ, compression, de-essing, noise gate; toggles settings.
Indicates when the effect is engaged.
Bypasses the harmony effect, but not reverb or Tone status.
Illustrates connecting the Harmony Singer 2 to microphones, mixers, and guitars.
Selects single or combined harmony voices. Chart shows name and pitch intervals.
Details on replacing the 4 AA batteries, observing correct polarity.
Automatically adjusts microphone gain for optimal signal without distortion.
Provides 24V phantom power for condenser microphones; does not affect dynamic mics.
Toggles effect on/off status via MP-75 microphone using footswitch.
To Next Page
