11 First-time use (Initial operation)
1. Setting up the machine
Place the machine on a solid, level surface that is
water- and heat-resistant.
Check that the used capsule container is pushed in as
far as it will go and that the drip grid is in place.
2. Filling the tank with water
Fill the water tank with fresh, cold tap water or drinking
water up to the MAX mark:
- Either pour the water into the water tank through
the hinged opening or
- pull the water tank upwards at an angle to remove it
and then fill it with water. When reinserting it, press
the water tank down slightly to ensure that the
valve in the base connects with the casing.
3. Pushing down the lever
The lever must be down. If necessary, push it down.
m
m
m
m
First-time use (Initial operation)
To Next Page
Loading...
