16
Other Information
Troubleshooting
Most problems you encounter with your TV can be corrected by consulting the following troubleshooting list.
Snowy dots and interference
If the antenna is located in the fringe area of a television
signal where the signal is weak, the picture may be
marred by dots. When the signal is extremely weak,
it may be necessary to install a special antenna to
improve the reception.
1.
Adjust the position and orientation of the indoor/
outdoor antenna.
2.
Check the connection of antenna.
3.
Fine tune the channel.
4.
Try another channel. Broadcasting failure may
happen.
Ignition
Black spots or horizontal streaks appear, or the picture
utters or drifts. This is usually caused by interference
from car ignition system, neon lamps, electric drills, or
other electrical appliance.
Ghost
Ghosts are caused by the television signal following
two paths. One is the direct path, the other is reected
from tall buildings, hills, or other objects. Changing the
direction or position of the antenna may improve the
reception.
Radio frequency interference
This interference produces moving ripples or diagonal
streaks, and in some case, loss of contrast in the
picture. Find out and remove the radio interference
source.
* To bring you better visual experience, please remove
all labels from TV front panel and screen before use.
No picture, no sound
1.
Check if the fuse or circuit breaker is working.
2.
Plug another electrical device into the outlet to make
sure it is working or turned on.
3.
Power plug is in a bad contact with the outlet.
4.
Check the signal source.
No color
1.
Change the color system.
2.
Adjust the saturation.
3.
Try another channel. Black-white programme may
be received.
Remote control does not work
1.
Change the batteries.
2.
Batteries are not installed correctly.
No picture, normal sound
1.
Adjust the brightness and contrast.
2.
Broadcasting failure may happen.
Normal picture, no sound
1.
Press the button to increase volume.
2.
Volume is set to mute, press the button to
restore sound.
3.
Change the sound system.
4.
Broadcasting failure may happen.
Unorderly ripples on the picture
It is usually caused by local interference, such as cars,
daylight lamps and hair driers. Adjust the antenna to
minimize the interference.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
