To Next PageTo Next PageWhat to do if there is a risk of damaging components nearby while rewelding or disassembling TCL Alcatel Idol4 Cell Phone components?
To prevent damage to nearby components during rewelding or disassembly of TCL Cell Phone components, apply high-temperature adhesive tape to the components in close proximity to the work area.
How to reweld or disassemble/assemble components of TCL Alcatel Idol4 Cell Phone?
To reweld or disassemble/assemble components on your TCL Cell Phone, use a hot wind gun. Set the temperature to 330°C, the air level to 2-3, maintain a height of around 10mm, and apply heat for less than 60 seconds.
Why is the PCBA blistering when heating part of the PCBA with a hot wind gun of TCL Alcatel Idol4 Cell Phone?
If the PCBA of your TCL Cell Phone has been stored for more than 7 days and shows blistering after heating with a hot wind gun, it's likely because it wasn't baked beforehand. Bake the main PCBA in an oven before applying heat.
How to dry a damp PCBA in TCL Cell Phone after long time storage?
If the PCBA of your TCL Cell Phone becomes damp after long-time storage (more than 7 days), bake the main PCBA in an oven. The oven temperature should be 105°C, and the baking time should be greater than 8 hours.
General| Brand | TCL |
|---|---|
| Model | Alcatel Idol4 |
| Category | Cell Phone |
| Language | English |
