Factory Test & Alignment Specification For MT56 Series (V1.0)
10
3.5 Param Setting Menu
Param Setting menu contains Sound Setting, Picture Curve, Picture Setting, SSC, DBC, CI Card,
Overscan, WIFI CHECK and USB FILE. But it is exclusively used by R&D engineer, anyone else shouldn’t
change the settings in the menu.
Set sound mode, balance, sound scene, etc.
Set picture mode, brightness, contrast, backlight, etc.
Spread Spectrum clocking.
Exclusively used by R&D.
Dynamic Backlight Control.
Exclusively used by R&D.
Common interface Card switch.
To Next Page
Need help?
General
