Factory Test & Alignment Specification For MT56 Series (V1.0)
14
Appendix
Appendix 1: Warm-up Test
Following TCL standard and practices, it’s required minimum 15min of Warm-Up that can be considered
as Burn-In. Additional aging for White Balance alignment is no more necessary due to consistent picture
performance with cloning usage. This function is accessible by selecting “Factory menu Warm up”,
pressing RCU “Right” or ”Left” key to set it ON, and then it enter in Warm up mode. Press “Menu” key on
keyboard to exit the burning mode. Other faster methods are available on above enclosed SIACP
requirements (rev. v3.9).
To Next Page
Loading...
Need help?
General
