TCL PIXI 5-10 4G VF - Disassembly Process

L2E Repair Document TCL Communication Ltd.
Rev.
VF1300 Level 2E Repair Document
Page
1.0
11/39
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
6
SIM card pin

7
Suction cup

8
Solder iron

9
Hot wind gun

4.3 Disassembly process
The steps of disassembly are as below.
Step1: Open the SIM slot cover, take off one screw (set the torques at 0.7kgf.cm if using electric
screw driver, set the torques at 0.8kgf.cm if using manual screw driver), and then remove the back
cover by prying up from down left side of the tablet as following illustrated picture.