TCM FB10-7 - Page 108

ltems to be checked
е Sheaves — Operation, damage and looseness
e Rollers (end, side and retaining) — Operation, looseness and
damage
* Cylinders (lift and tilt) - Operation and oil leaks
e Attachments — General condition and installation
* Major bolts and nuts — Retightening (new loaders only)
• Chassis — Lubrication
PERIODICAL CHECK
B LUBRICATING LIFT CHAIN
Apply engine oil to the lift chains using a lubricator or brush. To
allow oil to enter between each pin and link plate of the lift
chain, observe the following conditions:
1) Loosen the chain sufficiently.
2) After applying engine oil, move the mast up and down fully
at least 10 times.
ДР NOTE
If your lift truck is used near a port or coastal area, the lift
chains might be damaged by salty breeze. After a storm or
typhoon, it is advisable to wash them with fresh water before
lubricating in the manner described above.