TCM FB10-7 - Page 27

LVAL MANJINA
A Do not tiit the mast with loads high
Use
minimum
forward
and
reverse
tilt
when
stacking
and
unstacking
loads.
Never
tilt
forward
unless
the
load
is
over
stack;
otherwise
the
truck
might
tip
over.
А Do not lift or start with mast tilted forward
When
the
mast
is
tilted
forward,
do
not
perform
the
following
operations:
lifting
the
forks
and
starting
and
traveling
the
truck.
Аһ
Do
not
stack
or
unstack
loads
on
a
sloping
grade
A Keep the chains tight
A
slack
chain
means
the
mast
rail
or
carriage
hang-up,
which
might
cause
the
sudden
fall
of
loads
or
carriage
or
the
truck
to
tip
over.
Keep
the
lift
chains
stretched
tight
at
all
time.
A
Donotuse
your
truck
for
purposes
other
than
specified
«
Do
not
use
the
truck
to
open
or
close
the
doors
of
freight
cars
or
warehouses.
1-23
• Do not push other trucks.
• Do not hoist loads, using ropes hung on the forks.
• Do not tow another vehicles.
• Do not push or pull loads with forks; otherwise, the load might
fall off or get damaged. In particular, the truck with the max. lift
height of more than 150 cm might tip over, if you try to do that.
A Adjust fork spacing properly
Adjust the fork spacing suitable according to the size of the load.
Á Adjust fork spacing with your feet
Adjust the fork spacing with your feet. Do not use your hands. You
hands might get pinched between the forks and carriage.
А Make sure forks are securely locked
After adjusting the fork spacing, lock the forks with fork stoppers.
Unlocked forks will slide during traveling, causing the load to fall
off.