TCM FB10-7 - Page 56

INSTRUMENTS AND CONTROLS
SS
Mode gx
a
HABERE Sh
==
ОЕ
ТТТ
12345678
(Р) ІСІ
HB8BBBB.Bn Кт
MOTOR OVERHEAT WARNING LIGHT HOUR METER FAILURE CODES
This light blinks when the drive motor has Тһе hour meter indicates the total time the [ға failure occurs, the "wrench" mark appears
overheated. It is usually lit. key switch has been in the ON position. along with a 3-digit number. If this is the case,
If it starts blinking, stop the operation consult your TCM dealer.
immediately and wait until the light stops
blinking.
ТГ NOTE
For more information, see page 5 - 7 of
Service Data.