TCM FB20-7 - Page 81

HANVLING INE DALIEMNT
6)
Press
the
“Start”
button
on
the
charger
control
panel.
The
“Charging
in
progress”
lamp
lights
up
and
charging
starts.
While
charging,
you
can
hear
the
transformer
buzzing.
The
truck-mount
type
charger
won't
start
charging
if
the
AC
power
supply
is
not
turned
on
or
battery
receptacles
are
not
connected.
7)
When
the
battery
is
fully
charged
in
8
to
13
hours
after
the
start
of
charging,
the
charger
automatically
stops
operation
and
the
"Charging
in
progress"
lamp
goes
out.
The
length
of
time
required
for
charging
varies
with
the
amount
of
discharge
of
the
battery.
8)
After
charging
is
completed,
make
sure
the
"Charging
in
progress"
lamp
on
the
charger
control
panel
goes
out.
Turn
the
power
supply
switch
off
and
remove
the
plugs
of
the
charger.
9)
Before
trying
to
start
the
truck,
make
sure
to
measure
the
specific
gravity
of
each
cell
of
the
battery.
Fluid temperature Specific gravity
10°С 1.287
20°С 1.280
30°C 1.273
40°C 1.266
10) Do not remove the plugs while charging.
If you need to remove any plug while charging for any reason,
follow the procedure below:
(Т) Press the stop button.
@)Turn the power supply switch OFF.
(8) Remove the plugs.
^R? NOTE
When removing the plug, hold the plug body, not the cord;
otherwise the wires may be broken.