To Next Page

A26 Battery Replacement Instructions

Caution: Disconnect the AC power adapter and place the power switch in the OFF

position before beginning the replacement.

1. Lift the two rubber pads at both ends of the bottom of the A26. Set these aside

for reinstallation after the battery replacement.

2. Remove the two screws on the bottom right end of the unit base using a T-10

TORX driver.

3. Using a flat bladed screwdriver, slide the base cover all the way to the left. It

should then be possible to lift the base cover away from the A26 body.

Other manuals for TDK A26

Questions and Answers:

Need help?

Do you have a question about the TDK A26 and is the answer not in the manual?

General