Troubleshooting
Problem/Issue Cause Solution
Cannot bind drone to
controller
a) Battery
b) Electromagnetic interference
c) Out of range
a) Make sure the batteries in both drone and
controller are fully charged
b) Clear out objects between drone and controller
c) Put drone and controller closer to each other
Drone does not turn on
a) Battery too low
b) Battery not fully plugged in
a) Charge battery
b) Reinstall the battery
Controller does not turn on
a) Switch didn't turn on
b) Battery wasn't installed
correctly
c) Battery power too low
a) Ensure switch is turned on
b) Ensure battery fully and correctly plugged
c) Charge the battery
Blades do not spin or
drone has difficulty taking
off the ground, LEDs are
flashing
Battery power level is too low
Fully recharge the battery
Unstable drone flying /
drifting sideways
Damaged blade(s) Replace the blade(s)
Gyro off-balance Recalibrate and trim the drone as necessary
All blades spin but drone
does not take off the
ground or not flying
properly
Blades are not installed correctly
Reinstall the blades following the "Blade
Installation" section
Drone crashes during 360°
Flip
Not enough space to perform
the rolling function
Ensure the drone is at least 9ft from ground and
9ft away from all other objects in all direction
Drone can not perform
360° Flip and LEDs are
flashing
Battery power level is too low Fully recharge the battery
Cannot take photo or video
Micro SD Card not installed
correctly or damaged
a) Ensure Micro SD Card is fully inserted
b) Replace Micro SD Card
Blades are not installed correctly Reinstall the blades following the "Blade
Installation" section
To Next Page
Loading...
