Battery installation
1
Open the cover of the remote control unit.
2
Insert two AAA batteries. Make sure that the batteries are
inserted with their positive ¥ and negative ^ poles
positioned correctly.
3
Close the cover.
Note before using the remote control
Press the AMP button to switch to the AMP mode before operating o
the unit by using the remote control.
The effective range of the remote control is no greater than 10m o
and an angle no greater than 30 degrees.
Buttons that are not listed or mentioned in the remote control o
diagram are not used for this unit. It is normal that there will be no
response when you press them.
To Next Page
Loading...
