TASCAM MD-CD1 RS-232C Protocol Specification
12 TEAC Corporation
DIRECT TRACK SEARCH PRESET
Searches for the specified track number.
When this command is received while in STOP mode or PLAY mode, the controlled device will enter
PLAY mode after searching. If the controlled device had been in any other mode when searching
began, it will remain in that mode after searching.
Command 23
Machine ID 0
Data 4 bytes
Description Remarks
Data 1 Tens digit of the
track number
Data 2 Ones digit of the
track number
Data 3 Thousands digit of
the track number
Data 4 Hundreds digit of
the track number
Track number
Example) 2301: track 123
・ If the specified track number does not exist on the disc, the CD-RW901 will transmit ILLEGAL
[F2].
Return none
PITCH CONTROL DATA PRESET
Specifies the playback pitch of the controlled device in % units.
The adjustable range is ±16.0%.
This can be set independently of the step that is specified by the CD-RW901's PITCH STEP? setting.
A return command is returned only if Sense [FF] is specified..
If Sense [FF] is specified, the data is two bytes.
The pitch control mode setting is made by the command "PITCH CONTROL SELECT [35]."
Command 25
Machine ID 0
Data 4 bytes or 2 bytes
Data
1
Data
2
Data
3
Data
4
Description Remarks
0
1
Positive value
Negative value
N2 N3 N1
Preset %
N1：Tens digit, N2： Ones digit, N3：First decimal
place
Example) 2311：-12.3%
F F … Sense Requests that the currently preset pitch be
returned.
・ If data other than the above or data outside the specified operating range is received, the
CD-RW901 will transmit ILLEGAL [F2].
Return PITCH DATA RETURN [A5]
AUTO TRACK TIME PRESET
Specifies the Auto Track Time setting of the controlled device.
The range that can be specified is 1 to 10 minutes.
A return command is returned only if Sense [FF] is specified.
The Auto Track Mode setting is made by the command "AUTO TRACK SELECT [31]."
Command 26
Machine ID 0
Data 2 bytes
Data 1 Data 2 Description Remarks
To Next Page
Loading...
