Teac CD-RW901SL - Page 21

TASCAM MD-CD1 RS-232C Protocol Specification
20 TEAC Corporation
PITCH CONTROL SELECT
Specifies the Pitch Control mode of the controlled device.
A return command is returned only if Sens [FF] is specified.
The pitch control value is specified by the command "PITCH CONTROL DATA PRESET [25]."
Command 35
Machine ID 0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 Pitch Control Off
0 1 Pitch Control On
F F Sense Requests that the preset content be returned.
・ If data other than the above is received, the CD-RW901 will transmit ILLEGAL [F2].
Return PITCH CONTROL SELECT RETURN [B5]
AUTO READY SELECT
Specifies the Auto Ready mode setting of the controlled device.
A return command is returned only if Sense [FF] is specified.
Command 36
Machine ID 0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 Auto Ready
Off
0 1 Auto Ready
On
F F Sense Requests that the preset content be returned.
・ If data other than the above is received, the CD-RW901 will transmit ILLEGAL [F2].
Return AUTO READY SELECT RETURN [B6]
REPEAT SELECT
Specifies the Repeat Mode setting of the controlled device.
A return command is returned only if Sense [FF] is specified.
Command 37
Machine ID 0
Data 2 bytes
Data 1 Data 2 Description Remarks
0 0 Repeat Off
0 1 Repeat On
F F Sense Requests that the preset content be returned.
・ If data other than the above is received, the CD-RW901 will transmit ILLEGAL [F2].
Return REPEAT SELECT RETURN [B7]