Teac CD-X10I - Setting Timer Start and Stop Times; Selecting Timer Source

24
Setting the Timer
< The unit can be programmed to turn on and off at a specified
time.
<
Adjust the clock before setting the timer.
Press and hold the TIMER button for more than 2
seconds and release it when the “hour” value starts
blinking.
1
“TIMER” and “ON” indicators appear on the display.
<
When no button is pressed for 7 seconds, the timer setting
mode will be cancelled.
The “minutes” value starts flashing.
Press the SKIP button (.//) to set the start time
(minute), and then press the TIMER button.
3
“TIMER” and “OFF” indiactors appear on the display and the
“hour” value starts flashing.
Press the SKIP button (.//) to set the start time
(hour), and then press the TIMER button.
2
Press the SKIP button (.//) to set the stop time
(minute), and then press the TIMER button.
5
The “minutes” value starts flashing.
Press the SKIP button (.//) to set the stop time
(hour), and then press the TIMER button.
4
Press the SKIP button (.//) to select a source
(iPod, CD or TUNER), and then press the TIMER button.
<
You cannot select “AUX”.
6
TIMER
/