Teac CG-10M - Specifications; Clock outputs; OCXO (crystal oscillator); General

EN
15
Specifications
Included items
Power cord × 1
Owner’s manual (this document) × 1
Pads × 3
o Design and specifications are subject to change without notice.
o Weight and dimensions are approximate.
o Illustrations in this manual might differ slightly from production
models.
Clock outputs
BNC connectors ................................................... 4
Output sampling frequency ................................ 10MHz
Output impedance ............................................ 50Ω
Input level ................................................. 0.5Vrms
(sine wave)
OCXO (crystal oscillator)
Clock stabilization time .............................about 2 minutes
(time until oscillator stabilizes after unit turned on)
o Even after two minutes have passed, operation to further increase
stability will occur following temperature changes inside the
oven. For this reason, we recommend allowing it to warm up for
about 10 minutes before actually using it.
Frequency temperature characteristic ................ within ±3 ppb
Frequency precision ..........within ±0.1 ppm (when shipped new)
(ppm = 10
−6
, ppb = 10
−9
)
General
Power supply ....................................... AC 220V, 50Hz
Power consumption ..................... 15.8W (while warming up)
10.8W (when stable)
External dimensions (W × H × D, including protrusions)
290 mm × 84.5 mm × 248.7 mm
Weight ....................................................... 3.6kg
Operating temperature .............................. +5°C to +35°C
Operating humidity range ............ 5% to 85% (no condensation)
Storage temperature range ......................... −20°C to +55°C