Need help?Do you have a question about the Teac FD-55 and is the answer not in the manual?
General| Form Factor | 5.25 inch |
|---|---|
| Interface | Shugart |
| Capacity | 360 KB |
| Speed | 300 RPM |
| Height | 3.25 inches |
| Track-to-Track Access Time | 6 ms |
| Media Type | Double-sided, double-density |
| Average Access Time | 94 ms |
| Data Transfer Rate | 250 Kbps |
| MTBF | 10, 000 hours |
Details the correct procedures for inserting and removing disks from the FDD.
Explains signal and power connector types, cable requirements, and interface connections.
Details the use of internal straps and terminators to configure the FDD for system compatibility.
Discusses methods to observe and mitigate the effects of external inductive and switching noise on FDD operation.
Explains the FM encoding method used for single-density data recording.
Details the MFM encoding method used for double-density data recording.
To Next Page
