4. INITIAL
SETUP & INPUT SOURCES
4.1 Ini
tial Power On
When
the TV is turned on the first time out of the box or after a factory settings reset, it will
prompt you to run auto channel tuning.
1.
Connec
t the TV to your antenna wall socket using a coaxial TV cable.
2.
After mak
ing sure all connections are secure, plug in the power cord and turn on AC
power.
3.
Press o
n the remote control to turn on the TV.
4.
The T
V will initialise and prompt you to choose between Home Mode and Shop
Mode. Home Mode is recommended for optimal energy saving. Choose with
and
press to proceed.
5.
Nex
t, a tuning menu will display. Adjust the settings with
and p
ress to
start tuning.
6.
Aft
er tuning is complete, the TV will display programmes from detected channels.
NOT
E: If no channels are detected, please check the connection and condition of your
external antenna.
4.2 Selecti
ng an Input Source
To pl
ay different media types and from any connected
external device, change input sources to activate the
desired connection.
1.
Press t
o display the list of input sources.
2.
Press to ch
oose an input source.
3.
Press to confirm.
DTV, USB and HDMI can also be accessed using the
shortcut buttons and .
This TV starts in DTV mode by default when it is switched
on for the first time. Subsequently, it will start in the most
recently selected inp
ut mode.
N
O
T
E: Please make sure the device is connected
before selecting the input source.
10
3D Video Playback
USB Multimedia
Blu-Ray Disc Player
Playback
Initial Setup &
Input Sources
Remote Control
On-Screen DisplayTV & Electronic
Programme Guide
Digital Video
Recording (DVR)
(OSD) Menu
Reference
To Next Page
Loading...
