Teac MC-DX40DAB - Setting the Timer

28
Setting the Timer
TIMER
STANDBY/ON
/
The unit can be programmed to turn on and off at a specified
time.
Adjust the clock before setting the timer.
1
Press and hold the TIMER button until “TimerOn” appears
on the display.
The “hour” value starts flashing.
When no button is pressed for 60 seconds, the timer setting
mode will be cancelled.
2
Press the skip button (.//) to set the start time
(hour), and then press the TIMER button.
The “minutes” value starts flashing.
<
<
<
3
Press the skip button (.//) to set the start time
(minute), and then press the TIMER button.
“TimerOff” appears on the display and the “hour” value starts
flashing.
4
Press the skip button (.//) to set the stop time
(minute), and then press the TIMER button.
The “minutes” value starts flashing.
5
Press the skip button (.//) to set the stop time
(hour), and then press the TIMER button.