Teac MT-20D-IO - Page 106

(c) How to extract the contacts
To extract the contacts inserted into the housing, pullout the
cable with tweezers, while opening the stopper of the housing with
the edge of a cutter knife.
Open
Contacts
Stopper (lift up)
Open
Fig. 404 Sectional view of housing (black connector)
(d) How to insert the contacts
Insert each contact in such a direction that its proj ection is
placed on the stopper side of the housing.
After insertion, pull the cables lightly with tweezers to make
sure that the contact is inserted exactly.
The terminals of the housing are assigned with odd numbers on the
triangular mark side, and with even numbers on the opposite side
with the triangular mark as No.1.
Triangular mark
1 7
m
2 8
Fig. 405 Terminal numbers
- 4013 -