Need help?Do you have a question about the Team C TC02 EVO Competition Buggy and is the answer not in the manual?
General| Brand | Team C |
|---|---|
| Model | TC02 EVO Competition Buggy |
| Category | Motorized Toy Car |
| Language | English |
Provides essential safety and operational guidelines for the RC car.
Details power switch, battery indicator, trim controls, and switches.
Guidance on antenna extension and transmitter crystal usage for frequencies.
Instructions for opening the battery cover and installing transmitter batteries.
Covers radio system setup, start/finish procedures, and required tools.
Details assembly of front suspension parts including E-rings and hinge pins.
Continues front suspension assembly with screws and ball studs.
Illustrates buffer assembly with ball bearings and ball studs.
Shows buffer assembly using block carriers and washers.
Details mounting front suspension parts with screws.
Illustrates front suspension assembly with E-rings, hinge pins, and bearings.
Shows installation of ball ends and adjust rods for front suspension.
Details front suspension assembly using ball studs and screws.
Illustrates differential gear assembly with components and grease.
Details assembly of transmission gears and shafts with ball bearings.
Shows mounting motor plate and mounts using screws and threadlocker.
Illustrates main gear assembly with flanged nylon nuts.
Details rear damper tower assembly using screws and ball studs.
Shows rear bulkhead assembly using ball studs and screws.
Details rear chassis component attachment using screws.
Illustrates rear suspension assembly with hinge pins and screws.
Continues rear suspension assembly with screws.
Details mounting rear transmission components using screws.
Shows assembly of rear shock tower and fender using screws.
Details rear suspension assembly using ball studs, shafts, and E-rings.
Continues rear suspension assembly with hinge pins, washers, and E-rings.
Shows rear suspension assembly with ball ends and adjust rods.
Details main chassis assembly using screws and chassis plates.
Illustrates front shock absorber assembly with pistons, O-rings, and washers.
Details rear shock absorber assembly with springs and adjusters.
Explains how to adjust spring tension and compress springs for installation.
Shows front suspension assembly with shock absorbers, nuts, and screws.
Details rear suspension assembly with shock absorbers, nuts, and screws.
Illustrates motor installation with washers, screws, and grease.
Guides selection and installation of steering servo with parts and screws.
Shows receiver and ESC installation using double-sided tape.
Instructions for installing batteries, including handling loose cells.
Details assembly of front and rear wheels, tires, and rims.
Provides dimensions and guidance for body mounting with clips, nuts, and screws.
To Next Page
