To Next PageTo Next Page
Need help?Do you have a question about the Team C TC10 and is the answer not in the manual?
General| Width | 200mm |
|---|---|
| Drive Type | 4WD |
| Motor | Brushed 540 |
| Battery | 7.2V NiMH |
| Tire Type | Rubber |
| Scale | 1:10 |
Identifies all parts of the radio transmitter, including controls and indicators.
Instructions for opening the battery cover and installing batteries correctly.
Steps for connecting the battery and powering up the transmitter and ESC.
Lists essential tools needed for building and maintaining the RC car.
Assembles the first two steps of the gear differential using Bag-A components.
Continues gear differential assembly with Bag-A components across two steps.
Finalizes gear differential assembly with Bag-A components over two steps.
Detailed steps for assembling the solid axle using components from Bag-A.
Attaching motor mounts and side panels to the main chassis.
Installing the center gear adaptor onto the chassis.
Assembly steps for differentials using Bag-B parts, covering two steps.
Mounting side panels onto the chassis cover.
Attaching the front and rear shock towers to the chassis.
Guides for assembling both front and rear lower arms.
Instructions for attaching arm mounts and projection seats.
Attaching the front lower arms to the chassis structure.
Detailed assembly of the rear lower arms.
Instructions for assembling turnbuckles for suspension links.
Assembly steps for the steering system, covering two parts.
Final assembly steps for the steering system.
Instructions for installing the top deck of the chassis.
Steps for assembling the Constant Velocity Drive (CVD) components.
Instructions for assembling the rear hub carriers.
Assembly of front hub carriers, covering two distinct sets.
Detailed instructions for assembling turnbuckles.
Steps for assembling the rear suspension arms.
Assembly of the front suspension arms.
Instructions for installing the servo arm.
Steps for assembling turnbuckles.
Instructions for installing the front swaybar.
Steps for installing the rear swaybar.
Initial assembly steps for the shock absorbers.
Continues shock absorber assembly with specific components.
Further assembly and setting of shock absorbers.
Final shock absorber assembly and rebound adjustment.
Instructions for assembling the front bumper.
Completing the front bumper assembly.
Attaching the front body mount to the chassis.
Installing the front shock absorbers.
Attaching the rear body mount to the chassis.
Installing the rear shock absorbers.
Mounting the steering servo to its plate.
Attaching the steering servo assembly to the chassis.
Installing the motor and its gear.
Mounting the Electronic Speed Controller and receiver.
Assembling the chassis frame and battery support.
Installing the battery and tyres onto the chassis.
Adjusting shock absorber settings for optimal performance.
Tuning transmission and differential characteristics.
Adjusting tire and traction parameters for track conditions.
