2
3. Connection Diagram:
Installation Tips:
1. Connect the speed control to the receiver position channel 2.
2. Connect blue power wire to motor “A” solder-tabs
3. Connect yellow power wire to motor “B” solder-tabs
4. Connect orange power wire to motor “C” solder-tabs
5. Connect the hall sensor cable between the speed control (underneath the solder taps) and motor
6. Connect red power wire to battery “Plus”
7. Connect black power wire to battery “Minus”
Point to notes:
1. All power wires should be connected properly according to the color indicator and avoid
creating solder bridges on the solder tab
2. Avoid soldering longer than 5sec per soldering joint when replacing the power wires on the
speed control
3. When connecting the battery to the speed control, please make sure the battery + or – should be
connected properly.
Please make sure to follow the above tips and notes to install the speed control, otherwise, the speed
control may be destroyed due to the improper connection of the wires.
To Next Page
Loading...