8
7. Points to Note:
Step 2: How to program the mode function setting:
◎ Press the Mode Left/Right key to select the mode setting
◎ Press the Item Up/Down key to select the mode setting values
◎ After all values has been set, please pull out the speed control BEC wire from the
program card, then a beep sound will be heard that mean all values will be updated and
stored inside the speed control
Reset all Setting parameters:
If factory default setting wants to be restored, press and hold Mode Left/Right keys for
1s, then there will be a message “Data Reset, Remove RX Wire” shown on the LCD.
After BEC wire is pull out from the speed control, all settings value inside the speed
control will be reset to factory default setting.
Firmware Version Display:
Press and hold Mode Left/Item Down keys for around 2s, then the firmware version
number will be shown on LCD. If Mode Left/Mode Right key is pressed again, then it
will returned back to the last setting display location.
1. Once all data are reset, neutral point position is also reset. In this case, please
remember to base on Section 4 to set the throttle position again.
2. When the Low Voltage Protection is activated, an RED light on the speed control
will be flashing that mean the voltage is too low and need to change the battery.
3. When the Overheat Protection is activated, the speed control will have adaptive
system to control the max power output to the motor to avoid the burning problem.
To Next Page
Loading...