8
TEC-61231-23 Technical Manualе PRIZRAK
Warning signals after authentication
Additional sound signals after verification usually call for certain actions.
Table 3. Warning signals after authentication
Warning signal Source of a signal Actions to take
Long audio
signal
The default PIN code was not changed Change the default PIN code
The maintenance mode is on Disable the Maintenance mode
When installing the system, verication method
was switched to "RFID tag or PIN code"
Enter PIN code
(this conrms that verication method was
changed)
Five short audio signals
Battery in the RFID tag should be replaced Replace RFID tag battery
Other options
The system has several options to make your vehicle more comfortable and secure.
Geolocation of the vehicle
The system can show the vehicle position on the map at any moment. It
requires installation of a GPS/GLONASS-270 unit. To locate the vehicle, you
need to send a text message command or via voice menu or using your
mobile application.
Automatic window roll up
The system can be programmed so that the vehicle windows are
rolled up when engaging the lock.
Setting the electromechanical hood lock
You can install an additional hood lock and program the Alarm to
lock the hood when locking the vehicle, and open it only after identity
verication.
Central lock control
If your vehicle does not have an integrated door lock activated when
driving (locking) or turning off the ignition (unlocking), this option can
be provided by the Alarm system.
Microphone
A microphone provided with the Alarm system enables the driver
at any point to hear sounds inside the vehicle or in the vicinity. This
requires only one call to the Alarm system.
Optional parking system control
The Alarm system has exible algorithms to control additional parking
sensors. There are three control modes available, and the system can
be controlled by using original buttons in the vehicle.
To Next Page
Loading...
