TECEVO.CO.UK
CHARGE THE DEVICE
Plug the USB (5) charge / audio cable into an energized USB jack. Then
plug the MINI USB plug into the S-10 speaker. LED (3) will glow RED
while charging and go dark when battery is full. Maximum charge time is
2 hours.
NOTE: During use, the LED (3) will blink RED when battery needs
recharging.
AUX CONNECTION
Fit Y-cable’s 3.5mm stereo jack plug to audio player’s headphone or line
output mini jack. Fit Y-cable’s mini USB plug to S10 speaker.
Make sure there is no micro SD card in slot (7). Slide Power switch (2) to
‘MP3’ position. Rock and hold volume control (1) in + or – direction to
adjust playback volume level. Use volume control on music playing
device to adjust volume level.
MP3 PLAYER MODE
Using a computer to transfer MP3, WMA or WAV files onto micro SD
card. Push the card straight into slot, contacts down until card clicks into
place (7). Push again to remove. Slide Power switch (2) to MP3 mode
position. Single rock the volume control to ‘+’ jump to next file or ‘–
‘ previous file. Rock and hold MFB (1) in ‘+’ or ‘–‘ position for
comfortable volume level. LED (3) blinks GREEN during playback. If card
is removed or power is cut, the S10 will start at the last file played when
power or card is restored.
NOTE: Press the MFB (1) to switch between AUX input (6) and SD (7)
card playback.
To Next Page
Loading...