Tech Controllers EU-88 zPID - Fuel Type

9
This function allows you to set the blow force of the fan while in the Manual Mode.
Pressing the ENCODER activates the fan. The fan will operate until the ENCODER is
pressed again.
Press the ENCODER to enable / disable the central heating pump.
Press the ENCODER to enable / disable the (water heater) hot
consumption water pump.
Press the ENCODER to enable / disable the alarm.
.5. Fuel Type
This option allows you to select one of three fuel types (coal, fines and wood) for use
in the boiler. Each fuel type has a fan operation mode assigned to ensure the right
burning process.
.6. Central Heating Pump Activation
With this function, you can set the temperature that will activate the central heating
pump (the temperature is measured on the boiler). The pump will start if the setpoint
temperature is exceeded. The pump will be deactivated when the boiler temperature
C.H. Pump
H.C.W. Pump
Fan
C.H. Pump
H.C.W. Pump
Alarm
Fuel Type
C.H. Pump Activation
35
o
c
C.H. Pump
Activation
Blow Force
Fan
Manual Mode
Fuel Type
Coal
Fines
42
O
c | 55
O
c
C.H. Setpoint D
42
O
c | 55
O
c
C.H. Setpoint D