TECHCON SYSTEMS TS250

Questions and Answers

J
Jamie SullivanAug 2, 2025
What to do if my TECHCON SYSTEMS TS250 will not actuate?
- S
  Sabrina GayAug 3, 2025
  If your TECHCON SYSTEMS Dispenser system won't actuate, first check the foot switch connection. If the connection is correct, the foot switch may need repair or replacement. Also, inspect for broken wires or loose connections inside the unit after unplugging the power cord and disconnecting the air supply. Other potential causes include a defective solenoid or a defective PC board, which would require replacement.
L
Lori MaynardAug 9, 2025
Why is my TECHCON SYSTEMS Dispenser dispensing inconsistently?
- K
  Kim CunninghamAug 9, 2025
  If your TECHCON SYSTEMS Dispenser is showing inconsistent dispensing, try reducing the vacuum setting to address potential air bubbles in the adhesive. You might also need to increase the dispensing time. If the issue persists, the dispense needle may be clogged and require replacement.
G
gjohnsonAug 15, 2025
What to do if my TECHCON SYSTEMS TS250 will not pressurize?
- D
  Douglas ReedAug 15, 2025
  If your TECHCON SYSTEMS Dispenser system will not pressurize, first increase the air supply pressure. Then, check the air hose connections to ensure they are properly plugged in. If the issue continues, the regulator may be defective and need replacement.
J
Jacob SloanAug 20, 2025
Why TECHCON SYSTEMS TS250 Dispenser will not pull vacuum?
- H
  Heather HillAug 20, 2025
  If your TECHCON SYSTEMS Dispenser system will not pull vacuum, first increase the vacuum setting. If the issue persists, the solenoid valve, vacuum venturi, or vacuum needle valve might be defective and require replacement.
J
johnsonsarahAug 26, 2025
How to fix TECHCON SYSTEMS Dispenser LCD when it does not light?
- J
  Jessica WareAug 27, 2025
  If the LCD on your TECHCON SYSTEMS Dispenser does not light up, check the power cord connections and ensure the power is turned on. This should resolve the issue if it's due to no power input.

Summary

Safety

Intended Use

Defines the proper and improper applications of the equipment.

Safety Precautions

Lists essential safety measures for operating the dispenser.

Symbol Definitions

Specifications

Features

Connecting the Unit

Setup Instructions

Manual Dispense Cycle Setting

Step-by-step guide for configuring manual dispense operations.

Automatic Dispense Cycle Setting

Instructions for setting up automated timed dispense cycles.

Troubleshooting

Maintenance

Spare Parts and Accessories

Limited Warranty

I;O Configuration and End of Cycle Switch

TECHCON SYSTEMS TS250 Specifications

General

Dispensing Speed	Adjustable
Material Compatibility	Adhesives, sealants, lubricants, and other viscous materials
Viscosity Range	Up to 1, 000, 000 cps
Air Pressure Range	10 to 100 psi
Dispensing Volume	0.001 to 10 cc
Weight	Approximately 2.5 kg

TECHCON SYSTEMS TS250 - User Manual

Table of Contents