5
Model: TX-241; Article No. 5064; 02/2023
⚫ The manufacturer assumes no responsibility in the event of incorrect use resulting
from failure to follow the instructions for use.
⚫ Modification or alteration of the product will affect the product safety. Caution: Risk
of injury!
⚫ All modifications and repairs to the device or accessories may only be carried out
by the manufacturer or persons expressly authorized by the manufacturer for this
purpose.
⚫ Make sure that the product is operated from a power source that is easily accessible
so that you can quickly disconnect the device from the mains in case of an emergency.
⚫ Never open the product without authorization. Never carry out repairs yourself!
⚫ Handle the product with care. It can be damaged by shocks, impacts or falling from
even a low height.
⚫ Keep the product away from extreme heat.
⚫ Never immerse the product in water or other liquids.
⚫ Technical changes and errors excepted!
Warning!
⚫ Do not tamper with or manipulate the micro inverter or other parts of
the equipment under any circumstances.
⚫ Risk of damage due to improper modifications!
⚫ Keep all contacts dry and clean!
Caution Risk of electric shock!
⚫ When operating this device, certain parts of the device are under
dangerous voltage, which can lead to serious physical injuries or death.
Therefore, follow the following instructions to minimize the risk of injury.
⚫ Disconnect the plug connection only in a de-energized state!
⚫ Before carrying out visual inspections and maintenance work, check that the power
supply is switched off and secured against being switched on again.
Caution, hot surface!
⚫ The surface of the micro inverter can become very hot. Touching the
surface can cause burns.
⚫ Mount the micro inverter in such a way that accidental contact is not
possible.
⚫ Do not touch hot surfaces. When working on the micro inverter, wait until the surface
has cooled down sufficiently.
Intended use
The micro inverter may only be operated with a fixed connection to the public power
supply. The micro inverter is not intended for mobile use. Modifications to the micro
inverter are generally prohibited. For changes in the environment, you must always
consult a qualified electrician. Assembly, installation and electrical connection.
To Next Page
Loading...
Need help?
General
