3
Inserting the memory card
The camera has no built-in memory, therefore insert a formated (with FAT32)
MicroSD card** up to 32GB (**not included) for saving files.
Attention: Do not insert the MicroSD card forcibly; refer to the marking on the
camera. The MicroSD card should have same temperature like the ambient
temperature. The camera will be short-circuiting influenced by environment
temperature and humidity. Notice protection for the camera when using it
outdoor.
If the capacity of MicroSD card is full, the camera will stop recording
automatically. The LEDs will go out (when Endless Capture is OFF).
Press the edge of the card gently to pop-out the MicroSD card.
Basic Operations
Turn On and Off the camera
Switch the MODE button to “Test/On” to turn on the camera.
Switch the MODE button to “Off” to turn off the camera.
System Setup
Switch MODE button to “Test”, then you can set the system parameters.
Press Up/Down button to switch between Video and Photo mode.
Press Menu button to open the setup menu.
Press Up/Down button to scroll through all menus. Then press OK
button to enter the options interface.
Press Up/Down button to scan all options. And press OK button to
confirm options.
Press MENU button again to turn back to last menu or exit the
setup menu.
Setup menu and function as below:
Mode: [Photo] / [Video] / [Photo & Video] (default). Select and press OK
button to confirm.
To Next Page
Loading...
General