You can set the interval time. The
time range is from 3 second to 24
hours.
For example, set the interval to 1
hour, the camera will take a photo
each hour. If the camera works for 24
hours, there will be 24 photos. These
photos will be converted into a video.
Options: [On] / [Off] (default).
Select and press OK to confirm.
Language: (set the language display on screen): [English] / [German] (default)
/ [Danish] / [Finnish] / [Swedish] / [Dutch] / [Spanish] / [French] / [Italian] /
[Portuguese]. Select and press OK button to confirm.
Endless Capture: [On] / [Off] (default). Select and press OK button to
confirm.
If you activate Endless Capture the device will capture photo or/and video,
depending on the mode you choose, until the storage of the MicroSD card is
reached. When the storage is full the recording will move on what means that
the oldest file (photo/video) will be deleted, every time a new motion is
detected.
Time & Date: [Set time & date] / [Time format] / [Date format].
Select and press OK button to confirm.
Press Up/Down button to adjust the values.
Select and press OK button to confirm.
Time format: selected between
24h (default) & 12h.
Press Up/Down button to adjust the values.
Select and press OK button to confirm.
Date format: select between
[dd/mm/yyyy] (default) /
[yyyy/mm/dd] / [mm/dd/yyyy].
Press Up/Down button to adjust the values.
Select and press OK button to confirm.
Set time lapse
Hr： Min ： Sec
00 00 30
Notification:Motion
sensors deactivated
To Next Page
Loading...
General