7
Photo Stamp: (stamp the date & time on the photos or not): [Time & date]
(default) / [Date] / [Off]. Select and press OK button to confirm.
Password Protection: [On] / [Off] (default). Select and press OK button to
confirm.
Set the power-on password of the camera. The password is four digits, each
digit ranges from 0 to 9. Attention: If you set the password, write it down to
make sure that you do not forget it!
Beep Sound: [On] / [Off] (default). Select and press OK button to confirm.
Open den Beep sound menu to turn On or Off the confirmation sound of the
buttons.
Format Memory Card: [Yes] / [No] (default). Select and press OK button to
confirm.
Attention: Formatting the memory card (FAT 32) will delete all data
permanently. Before using a new memory card or a card that has been used in
another device previously, please format the memory card.
Serial No.: [On] / [Off] (default). Select and press OK button to confirm.
Set the unique serial number for the camera. The number is four digits, each
digit ranges from 0 to 9.
Reset Settings: [On] / [Off] (default). Select and press OK button to
confirm.
Restore the camera to factory default settings including password, serial
number and so on.
Version: Look up the Firmware information of the camera.
Take Photos, Record Video, Playback
Switch the Mode Button to “Test”. In this mode, you can take photos, record
video and playback files manually.
To Next Page
Loading...
General