16
5. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off automatically to
prevent any injuries to the user and to prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting for 1
minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyze (please refer
to Self-Checking) to distinguish what type of error problem the machine is encountering.
PCB ERROR CODE AND SOLUTION (EWAY)
2. Safety key sensor broken
2. Open the meter, replace sensor under the safety
key
1. Change or rework the motor
2. Change or rework the speed sensor
3. Roller magnetic not work
3. Change or rework the roller
4. Change or rework the wire
E3:
Only caused
when use
'MODE' key
1. Motor speed cannot be control
3. Speed sensor does not work well,
no signal
No display on meter
Be sure the power is right.
If new treadmill, be sure the connect cable all pin is right.
If used treadmill, it maybe some PCB components broken or transformer broken. Let the engineer check use
multimeter.
Meter keys not work
All keys not work; no beep sounds，please check hand bar keys and meter keys will short circuit.
A part key not work, no beep sounds, please lift the meter sticker to check this key, sometimes is the key
board not works.
Treadmill stops automatically
When starting the treadmill, after seconds, show E1，main problem is speed sensor, please check speed
sensor, magnet on roller, and connect wire.
Speed sensor is a receiver for speed from roller and meter.
Before attempting any work on the treadmill, ensure that the power is off and the plug is removed
Do not use extension leads as it may lead to power decrease and failure.
To Next Page
Loading...
