Model Combinations
Combine indoor and outdoor units only as listed below.
COOLING ONLY MODELS R407C
Indoor Units
Outdoor Units
DSAV92C5TA- GRV92C5TA-
GRV92L5TA-
DSAV122C5TA- GRV122C5TA-
GRV122L5TA-
DSAV182C5TA- GRV180C5TA-
GRV180L5TA-
GRV180C7TA-
GRV180L7TA-
DSAV222C5TA- GRV220C5TA-
GRV220C7TA-
GRV220L7TA-
HEAT PUMP MODEL R407C
Indoor Units
Outdoor Units
DSAV92R5TA- GRV92R5TA-
DSAV122R5TA- GRV122R5TA-
DSAV182R5TA- GRV180R5TA-
GRV180R7TA-
DSAV222R5TA- GRV220R5TA-
GRV220R7TA-
Power Supply:
5:
220 - 240 V ~ 50 Hz
7: 380-400 V - 3N ~ 50 Hz
DRAIN
1
ELBOW
*
DECLARATION OF CONFORMITY
This product is marked as it satisfies Directives:
– Low voltage no. 73/23 EEC and 93/68 EEC.
– Electromagnetic compatibility no. 89/336 ECC, 92/31 EEC
and 93/68 EEC.
This declaration will become void in case of misuse and/or non
observance though partial of manufacturer's installation and/or
operating instructions.
37.4163.215.0 04/2003
EG
I
F
D
E
INSTALLATION INSTRUCTIONS
- Split system air conditioner -
COOLING ONLY MODELS
OPERA
TING LIMITS
Maximum conditions
Outdoor temperature : 43°C D.B.
Room temperature : 32°C D.B. / 23°C W.B.
Minimum conditions
Outdoor temperature : 19°C D.B.*
Room temperature : 19°C D.B. / 14°C W.B.
Model name GRVxxxL
* : –15°C D.B.
HEAT PUMP MODELS
OPERA
TING LIMITS
Cooling Maximum conditions
Outdoor temperature : 43°C D.B.
Room temperature : 32°C D.B. / 23°C W.B.
Cooling Minimum conditions
Outdoor temperature : 19°C D.B.
Room temperature : 19°C D.B. / 14°C W.B.
Heating Maximum conditions
Outdoor temperature : 24°C D.B. / 18°C W.B.
Room temperature : 27°C D.B.
Heating Minimum conditions
Outdoor temperature : –8°C D.B. / –9°C W.B.
*
Available only for heat pump models.
TAPPING
2
SCREW 3,5 X 13
ACCESSORIES SUPPLIED WITH THE UNIT
PARTS FIGURE Q.TY PARTS FIGURE Q.TY
RAWL PLUG 4
RECEIVER WITH
1
CABLE (5 mt)
REMOTE
1
CONTROL UNIT
AAA ALKALINE
2
BATTERY
TAPPING
2
SCREW 4 X 30
1.Standard screwdriver
2.Phillips head screwdriver
3.Knife or wire stripper
4.Tape measure
5.Level
6.Sabre saw or key hole saw
7.Hacksaw
8. Core bits ø 5
19. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for reburring)
16. Hex. key
Tools required for installation (not supplied)
To Next Page
Need help?
General
